Engineering

Start from an existing design, not from zero

NWIREDCORE provides custom hardware, firmware and system engineering. A project can start from an existing NWIREDCORE product or platform, adapted to a new application, or from a fully custom design. Starting from an existing design can reduce duplicated engineering effort, depending on the project requirements.

How it works

Two engagement paths

A. Build on existing NWIREDCORE technology

Take a Gateway, LoRa Hub, Sensor Node or platform as the starting point and adapt it: different interfaces, sensors, power budget, radios or firmware for a specific deployment.

B. Fully custom development

A new design from architecture through schematic, PCB, firmware, prototype bring-up and manufacturing preparation.

Starting points

Existing NWIREDCORE designs

Each of these can be a starting point for adaptation instead of a blank sheet.

Adaptation

What can be adapted

  • Gateway interfaces and configuration
  • Sensor Node interfaces
  • Sensor configuration
  • Power architecture
  • Communication options
  • Firmware
  • System and backend integration
Capabilities

Fully custom development

  • 01Hardware architecture
  • 02Schematic design
  • 03PCB design
  • 04Embedded firmware
  • 05Prototype bring-up
  • 06Debugging
  • 07Manufacturing preparation
  • 08System integration
Experience

Technologies and domains

Based on the current NWIREDCORE product work.

  • Industrial gateway and edge hardware
  • Cellular (LTE) and Ethernet connectivity
  • LoRa radio and GNSS
  • RS-485 and industrial sensor I/O
  • Low-power, battery- and solar-powered devices
  • STM32 and Raspberry Pi Compute Module platforms

Discuss an engineering project

Tell us what you are building and whether an existing NWIREDCORE design could be a useful starting point.

Discuss an engineering project